|
|
|
|
|
Go back and vote on this image.
|
Picture
Information
|
| URL:
http://riceornot.ricecop.com/?auto=21293 |
|
| Comments: 3 (Read/Post) Favorites: 0 (View) |
Submitted
on: 04-06-2003
|
 View Stats |
Category:
Vehicle Misc |
|
|
Description:
The Chevy conversion kit for the 928 project |
Showing page: 1 of 1
[ 1 ]
 |
| #1 |
4-06-2003 @ 12:21:28 PM |
| Posted By : Low-Tech Redneck |
Reply | Edit | Del |
All you need to get a SBC into a 928, aside from a custom oil pan thats already been put on the block, the "Y" shaped bars on the left rear are the motor mounts, the orange plate is the clutch, and is actualy a stock Centerforce, the bell housing and fork on the right is from a wrecked Corvette, and the flywheel is a custom-made one that will fit the output shaft for the 928, which is acualy not part of the tranny, it's lying on the left side of the table, the square plate adapts the whole clutch assemby to the torque tube that runs to the tranny itself, mounted in the rear of the car on the rear axle
|
|
| #2 |
10-30-2003 @ 02:31:14 PM |
| Posted By : mr_mcmunkee |
Reply | Edit | Del |
Ok, I'm interested...but it looks like no one else is. :(
|
Showing page: 1 of 1
[ 1 ]
Login to leave a comment
|
|
|
|
|
